Search results for query: *

  • Users: old school
  • Content: Threads
  • Order by date
  1. O

    nitrous oxide on a hypereutectic pistons

    Anyone out there ever ran any nitrous on Keith Black hypereutectic pistons? I've got a mild 1978 360 stock heads,mild cam and flat top Keith Black hypereutectic pistons. I am wanting to add about a 100 or 150 shot of nitrous. Will the pistons hold up to the gas. These are cast not forged...
  3. O

    727 Question

    Hello Guys This may be a dumb question but here goes. Do all 727 transmissions have the same tail shaft? If not what sizes and lengths do they come in? I have a 74 duster with a 360 and a 727 that came out of a dodge r//v. I've installed a 8 3/4 suregrip and I now need to get a drive...
  4. O

    Power steering turnes right

    O.K Guys Here is a head scratcher for you. I replaced the return line fitting on top of the power steering box. It was cracked and leaking. I pulled both peices off of the top of the box. 1 had a slide valve inside and the other had two springs and 1 small slide in it. I got the...
  5. O

    power steering fitting

    Has anyone got a return fitting for a power steering sector? It fits on top of the steering sector and attatches the to the return hose to the power steering pump. It has two bolts that hold it down and two o rings that seal it. The part number is 2537227. It fits on a 1974 duster. If...
  6. O

    360 trans to motor brace

    All right guys I need an expert on this one. I'm puttint a 360 into a formally 6 cyl 1974 duster. I've got a 727 automatic behind the 360. The motor I bought had a brace on the drivers side by the starter that goes from the lower part of the transmission bell housing up to about midway on the...
  8. O

    318 to 360 motor mounts

    O.K. Guys I'm sure this has been asked before but I can't find it in the forum anywhere. I am removing a 318 from a 1974 duster and installing a 360. Will the motor mounts off of the 318 fit the 360 or will I have to purchase new mounts. It is going to have a 727 behind it. Will everything...
  9. O

    360 torque converter question

    Hi guys I'm new to this site so if I don't follow proceedure correct me. I have a built 1978 360 truck engine that is assembeled and ready to go in my 74 duster. I'm removing a 318 that has a 727 transmission in it. The 318 and trans are 1976 out of a camper.The Question is. Can I resuse...
Back
Top