Search results for query: *

1970 h code duster now has a 512 back half car. Has run a 10.27 @ 130 with mid 1.40 60 ft times on pump gas.11.3-1 512 low deck with max wedge ported performer rpm heads that flow 315 cfm, have flow sheets.Ultradyne 640 lift solid flat tappet cam and a prosystems 1100 cfm dominator.New trans...

Does anbody happen to know the differance in weight between a feather duster deck lid with aluminum inner structure and a standard steel deck lid?

Spent the last couple years parts hunting and asking questions trying to get back to racing after a 5 yr hiatus.Started 4 times to build a drag car in that time and finally finished one 70 duster very pleased with performance 2nd pass after a easy shake down run of 10.60 went to [email protected] but...

I have a set of nos duster decals for a 1970 can anyone tell me if the even part numbers go on r.h. or left hand side.I assume odds and evens tell which side they belong to.Thanks

I found what I believe is a early barracuda trans im sure it is an a body but it has a companion flange not the normal slip yoke on out put it is a 4 speed with casting numbers of c 85639u can anyone verify what this fits?

Have caliper mounts,good calipers mounting bolts and prop valve from a post 73 abody 75.00 obo plus shipping if needed.

431 stroker rotating assembly.Comes with new 440 source h beam rods and .030 over flat top pistons as well as rings and a low deck modified factory steel 440 crank and a 1970 hp 383 block that has been rough bored to ensure that it would clean up at .030 and it did .Also can include your choice...

Have a mr gasket v gate shifter I no longer have a use for.Works well and comes with all linkage as well as 2 mounting adapters.Does not have shifter boot but I will throw in a a body shift tunnel that I started to modify for this shifter.Will work in many applications with 833 trans Asking...

Have a complete kelsey hayes frt brake system comes complete with prop valve and hoses, rotors and calipers will most likely need replaced but everything else is in good shape even backing plates asking 300.00 for everything or reasonable offer Sale pending

Would someone be able to tell me if kelsey hays spindle is the same as 9 inch drum spindle.I would like to convert to wildwood brakes and need to know if I need to locate different spinles and/ or controal arms.

Been working on my 64 coronet and lucked onto a duster project car now b bodys shoved off to side and full tilt on duster.This one doesnt need body work just engine so 431 I was building going in and coronets for sale.Any one into a max wedge racer I have a good start on one.Heres pict of new ride.