Search results for query: *

Any idea on when we can order, and what the cost is? - Christopher

Looks great!! Excited to see progress on this. When will full kits be available? -Christopher

I sent you a PM, junior636. - Christopher

So, how do I go about getting this?

Double post...

Pulled the wiring harness out of the dash, where he had it ran. There were three grounds that were not connected to anything. Connected them up, did a quick accelerator pedal reset, and DBW works great. Now to finish routing everything where I want it!! Sorry it took so long, but I work 7 12s.

I finally took a couple pictures. I will upload them and then send a few to your Inbox. - Christopher

Might be Saturday or Sunday evening, but I'll try to lift mine up and get a few measurements for you on it. That way you can judge and see if you think it'll work. - Christopher

If you are backfiring through the carb, I would look at double checking the timing on the motor. - Christopher

You can't set the fuel pressure with just the pump running and the car not running. It will read higher than what it will be when you start it up. You could have just lowered the fuel pressure too low when you adjusted it, if the car was off. - Christopher

I had issues with my secondary needle sticking open due to a small amount of trash. Have you cleaned both sides? Also, are you sure there are no vacuum leaks around where the carb bolts down? - Christopher

Shouldn't be a battery issue. Set the fuel pressure to 6 with the car running. Then adjust the floats. Does it rev up fine after you start it and just idle bad, or what? - Christopher

Also, make sure that you are adjusting your floats with the motor running, buddy. But be careful!! With the flooding, if your floats are correct, I'd look into replacing the needle/seat. Sounds like they aren't sealing off. - Christopher

Tighten the idle air mixture screws all the way in. Then go 1.5 Turns out, exactly. Do the opposite on the other side. That should get you to a position where you can idle. If not, check your idle rpms. May simply need to raise the idle up. After that, dial it in using a vacuum gauge. -...

Stock Hemi oil pan won't clear your rack? - Christopher

I think so, honestly. There isn't much clearance. - Christopher

73 Duster and 5.7 Hemi. - Christopher

I'd run one if it were sponsered. :) Work looks great, man. - Christopher

I contacted Hotwire through email, and have yet to have a response. - Christopher

Meh.... the previous owner just stuck the gauges in the whole that the stock gauges came out of, with no regard to how it looks. Loganscuda messaged me and walked me through a few steps, and I have some wire tracing and sensor fixing to do... lol. Sorry, I haven't paid attention to this thread...

So, thanks for letting me join!! Just picked up a hemi swapped 73 Duster. It's an unfinished project, but it cranks and runs. :) Here is my issue (keep in mind that I just bought it yesterday, and know little to nothing about it...)... the accelerator pedal (DBW) doesn't function. The...