Search results for query: *

Nice part, seal surface looks great, rubber looks nice too. 95.00

888 and 889 bars 6 cylinder 70.00 set 890 and 891 bars 8 cylinder 70.00 set Torsion bar crossmember cut out of 68 Dart -with trans mount and trans crossmember plus 4 bolts! 100.00 One set of real nice K frame bolts 25.00 one slightly bent strut bar, free Disc brake spindles and Caliper brackets...

New Mopar intake, un-ported. They are quite heavy so this one has been extensively milled, over 7 pounds removed! Some areas were 13/16" thick! Don't like dead weight on my speedy car. Intake looks nearly stock. Also a cool modification of the interconnection to improve street drive-ability...

Parts from out West Empty housing has ladder bar bracket, assembled 59.5" drum to drum 150.00- actually fit really nice in a Duster/Demon body Set of axles from above housing, has nice Timken bearings 150.00 Set of 10" drum brakes, backing plates from cop car, 2.5 Shoes, excellent hardware...

I tried to modify my last post, really fouled it up so trying again, thanks for patience... Excellent original parts from my 68 Dart A body . Empty rear end housing, brake lines, brass T fitting , vent bolt and hose SOLD Backing plates with cables and 10" shoes/ hardware still attached SOLD...

Aluminum Race Case and tail housing, many new parts purchased from Liberty. Needs assembly. Hemi 18 spline gearset , new seals, bearings, forks, etc. I think the case if from Direct Connection way back when. I was building a replica 68 SS Dart, now going in a different direction and selling all...

Just pulled from my Dart 8 3/4 Rear, has backing plates and brake parts still attached, no drums or center chunk. Includes park cables, brake "T" and lines, hose, Large bolt pattern M/E axles with non adjustable bearings, long studs, brake shoes look great. Clean Oklahoma metal! 600.00 Also...

Pulled off my 68 340 Dart, I bought this car as unfinished project, guy was building a bracket racer, He never got it running. Going in a different direction... K frame, engine mounts were cut off Upper control arms w/new ball joints and bushings UCA Cams, washers, nuts Lower control arms w/new...

Only run for short time, pulled due to swap for fuel injected engine package. Real clean. looks like I just took it out of the box. This is the newer aluminum version, much lighter than older ones. Cost 335 at summit. I'm selling for 250 plus shipping (19) Contact through private conversation...