Search results for query: *

My tachometer worked fine until a few weeks ago. Now the needle bounces all over the place with no correlation to the engine speed. :wack: I have a '71 340 with a Mopar Performance Electronic ignition and a chrome ECU. The tachometer is a Stewart-Warner Deluxe Series 0-8,000rpm. Does anyone...

The speedometer needle in my 1973 Dart recently decided to stop returning to zero when the car is stopped. It stays at 8 mph when stopped and is always 8 mph higher than the actual speed of the car when moving. How do I get the needle to go back to zero when stopped?

My '73 Swinger has a charging and/or wiring problem and I can't figure it out. :angry7::angry5::angryfir::angry1:angry9: Originally a 318 car, I got the car with no engine and have since installed a 340. It has a Mopar Performance chrome electronic ignition with a Mopar electronic voltage...

I'm trying to put the A/C unit back into my 1973 Dart Swinger since I live in Florida and it was disconnected when I bought it. My question is what covers the opening in the firewall where the evaporator coil tubes come through? :dontknow: (See 1st picture) My service manual (see 2nd...

I have a 1973 Dart Swinger with Factory A/C. It was apart when I got it and I am now trying to plumb the vacuum lines to the vacuum reservoir so that my heater/AC switches function properly. I have included pictures of the reservoir, along with a close up of its attachment sites. A picture of...

:help: I started the Dart today and after pulling out of the garage noticed the 340 was dripping antifreeze below the oil pan. Shut it off, got under the car and found a small hole in the middle freeze plug on the drivers side. I have never dealt with freeze plugs before. Where can I get just 1...

I have a crated 'Cuda ralley hood that needs to be transported from Columbus, OH to Cape Coral, FL. Can anyone here provide the service or recommend someone who can transport it? :help:

:help: Other than Just Dashes, who else restores dash pads? Were you pleased with the quality of the restoration and was the cost reasonable? Is it possible to restore it yourself (mine only has a few small cracks) and if so, how? Any recommendations, suggestions and /or advise appreciated. Thanks.

I would like to find an engine builder either on Florida's west coast or in central FL. Can anyone recommend an experienced, reputable builder in this area for a 340 stroker engine? Any help would be appreciated. Thanks.

In addition to my '73 Dart, I have a '70 'Cuda that's in desperate need of an interior makeover. All of the original plastic interior pieces (door panels, kick panels, rear quarter panels, console, window trim, etc.) were painted/dyed by the previous owner. Unfortunately, the work was poorly...

Neither are mine but someone maybe interested. http://fortmyers.craigslist.org/cto/1157882955.html Also, not an A-body, but I don't think you'll mind. http://fortmyers.craigslist.org/cto/1158099592.html

I will soon be beginning a 340 engine build using the following components: '71 cast iron block bored .60 over, Indy-Edelbrock aluminum heads, 422 stroker kit with Ross forged pistons and Eagle crank, Comp Cams hydraulic roller camshaft with a duration of 224 in. 230 ex. @ .050", Mopar...

:help: I am looking for an evaporator coil for a 1973 Dodge Dart. Preferably one that's been pressure tested and has no leaks. Are there any out there? :banghead:

](*,)I need a pair of spool type motor mounts for a '73 small block (340). E-mail me at [email protected] if you have a pair to sell. Thanks.:salute: