Search results for query: *

With tire selection being what it is for 15" rims, is anyone running a 17" on back and 15" on front on their '67 thru '69 Barracuda. Just wondering what it would look like.

Need a set for a rearend swap.

In the middle of installing kit on 68 barracuda. My lower control arm was the tab for sway bar end link. When I bolted the lower ball joint/ steering arm onto new spindle, the nut from the bolt is hitting the sway bar tab interfering with steering radius. Any help?

Need upper control arm for 68 barracuda

Need a good pinion snubber for my 68 barracuda with 8.75 rearend.

Looking for a good core to build a spare trans. Needs to be for small block. Going into 68 barracuda. The closer to southern Ohio the better.

Anybody know a reputable builder?

Anyone living in/around Lawrence Co. Ohio interested in getting together and helping each other work on their cars? I know I could aure use some help.

Looking for 3.23 gear for 8.75. Must b for 489 case. Posted this originally yesterday. Got replies from members but there must have been a glitch in system because I couldn't reply to conversations

What would cause the ground wire on the battery to get so hot that it literally melted the lead off the terminal. This occurred while cranking the motor over to start after setting a while. Any ideas?

ISO backing plates for 8.75 rearend. Need to be 10" x 2.5".

I'm looking for back plates for 8 3/4. Must be 10" x 1.75. Any reasonable offer considered. Thnx

I'm needing a rear set of 10" x 1.75" back plates for a 8.75 rearend. Must be reasonably priced. I'm located in Kitts Hill, Ohio. Thanks.