Search results for query: *

should have mentioned that it called for locations 1 through 4 for check balls.

When i did the shift kit i put in the check balls it called for. The tci kit required drilling a section of the valve body, but not the small hole that i see in the TransGo kit.

So i added a quart more and now is about 1/4 in over full on the dipstick. Shifting from 2-3 has greatly improved! thank you for that. One thing is that cruzing at 40 and flooring it does not result in kickdown to 2nd. I verified that the linkage is being pulled as far back as it can go at WOT...

sadly i dont know. The trans was out of a '78 coronet. When taking off slowly the 1-2 shift happens nicely around 15 mph. The 2-3 shift revs out and sometimes wont shift going over 40. If i get on it and let off then it seems to go to 3rd. It is inconsistent as the next time i take off it might...

Thanks for all of the suggestions. I will try adding more fluid and see if that helps. One other question. The kit had me set the kickdown band 2.5 turns from 72 in lb. Most of the advice is to go 2 turns. So my question is what does tightening or loosing the band do? could that be part of the...

Fluid is just below the full line. Other than the little bit high 2-3 shift it seems good. Just have this no pressure thing that I was mainly concerned about. If that is "normal" then I will work on the kickdown adjustment and see if I can get it

Honestly it was my first rebuild and I don't remember. I checked everything against the tci and stock specs.

The tci kit was a full rebuild kit with a shift kit. All clearances where in spec. The kit did not come with a new valve body, and I just modded the existing. The kit had tow, street/strip, and race. I followed the street steps. The drain back is exactly what it seems like. Is that normal...

I have a 318 with a 904 that I just rebuilt. I put in a tci shift kit and Hughes converter. At first it wouldn't shift to 3rd until way too high. I have been working the kickdown cable and got it better. I noticed the other day after it sat for a few days I started it up and went to take off...