Search results for query: *

Hello all, I am switching from an Edelbrock 650 to an efi. Looking for some key considerations I need to be aware of when picking the efi system. This is my first swap so any knowledge is better than whee I am now. I have a new tank, inside tank fuel pump and feed / return lines - just need...

Hello everyone, I read that to remove a bayonet shifter, a .01" feeler guage works. I've been trying for a while now and the guage gets in about 1/4 inch and then stops. Attempts to push it further results in the guage bending from the force required. At this depth I've pulled and yanked and...

Hi All, The PO redid the interior on my 1975 Duster and only installed a simple lap belt anchored to, what looks like, a random bolt under the seat. Can anyone provide pictures of where the retractable lap, or better yet, retracable 3-point seat belt mounts? I ask because the same PO recarpeted...

Hey everyone, Does anyone know where to purchase the below screws with button caps? I have a few stripped ones I'd like to replace but cannot seem to find these particular ones. I'd rather keep these rather than replace all of them with something else. A previous owner put these in. TIA

Hi everyone - if anybody knows where to obtain the referenced item could you please let me know? I can't seem to locate one anywhere (Year One, Ebay, Classic Ind, etc.) I've attached a borrowed picture from a past post of the passsenger side as reference. Any help would be appreciated. TIA

Can someone please tell me which forum (under the "Forums" tab) is the correct one for posting a 'part wanted' post? Thanks

A pair of front power bucket seats from a 2017 Chyrsler Pacifica. All motors work as new. All that you need is a 12v power and a ground wire to be operational. They includes the flip up rear video screens and inputs/outputs. Purchased for much more to install in my 1975 Duster but went another...

Hi Everyone, I was going to install a pair of buckets to replace the current bench but have changed direction on that. I want to keep my current bench seat but the drivers side is super soft / cratered like a 400 pound man was driving it for a long time. I sink 6+ inches down when I sit on it...

Hi Everyone, Not sure this is the best forum to post this. If not let me know. I need to find a shop to help me with work on my 1975 Duster. My current need is help replacing the front bench seat with a pair of bucket seats from a 2017 Chrysler Pacifica. I assume it will entail some bracket...

Hi everyone, I've reviewed many of the threads on this topic and be,ieve I have a plan to fix my issue. I have a 1970 383 engine in a 1975 Duster. I replaced both valve covers due to leaks. The drivers side is fine, however the passenger side is still leaking slightly. The gasket used was a...

Hello everyone, Are the attached pictures good enough for one of you all to determine type / size so I can order the correct pumpkin gasket? 1975 Duster - may not be original. As always, I appreciate the helpful knowlwdge.

Hi all, I recently picked up a 1975 Duster that was orginally a slant 6 auto. It's been through a number of owners and over the years it has become a 383 magnum, 4 speed. I've begun going through it and some of the many issues it has includes a leaking rear seal on the trans and a leaking o-ring...