Search results for query: *

In the market for a Pro-Street (1967-1972) Dart or 1970-1972 Duster-Street/Strip. Prefer turn-key but open minded. I live in the Cincinnati and would like to keep the search radius to ~450 miles. Thanks!

Looking for shop recommendations in the Cincinnati area. Thanks

The short story....... I removed my fuel pump (mallory 4140) as I thought it was bad. Before ordering a new one I thought I would jump straight off the battery and found that it works fine. I have a separate switch to power the fuel pump but can't figure out the issue where the issue is at...

:violent1:

Found oil likely mixed with coolant sitting on closed valves. Last week had coolant in the crank case due to what I thought was a loose intake manifold. Did a pressure check of the cooling system and only found two very small leaks, one due to a loose hose clamp and one from the thermo...

I am installing an intake gasket and the instructions state to not use chemical adhesives or sealers (felpro MS90109). With that said, should I use RTV around water ports and if so, how is this applied, i.e. between gasket & manifold, head & gasket, both, etc? The gasket has the small bead...

While installing a drain plug on my 8 3/4 I pulled out the large piece with a magnet (not the penny- :p ) it wasn't the only piece but by far the largest. How bad?

Want a kit for a mostly street sometimes strip '70 Duster. i have read on this site to avoid Summit brand; however, the posts are 2-3 years old so they may no longer apply. Any other brands to avoid? What brands are recommended?

Looking for ideas on replacing door panels. I would like to see custom work others have done or ideas where to purchase at a decent price. Not wanting to spend 300.00 as listed on ebay. Thanks in advance.

Some pics from 7/11/10.

Anyone going? Heading up tomorrow. Will take and post pictures.

Anyone have any experience using SPI e primer? I haven't seen any negative comments during my research but want to gain the thoughts and opinions of those who have used. Any competitive brands that would be recommended over SPI? If so, why? Thanks in advance.

Looking for the adhesive that is under hood between sheet metal and brace/frame of hood. It appears to have been caulked in. Thanks in advance.

Looking for LH & RH rockers for 1971 Duster...new or used. Reference material for replacement would be of help as well. Thanks