Search results for query: *

318 slight cam 270 solid lift, holley 600, points distributor idles fine accelerates excellant but runs rough at crusing speed under light load? Any ideas? Thanks.

I'm considering making the cutout the same on the passenger side of the crossmember just like the driver side to allow room for dual exhaust. There are a pair of holes that will be cut away, anybody know what they are for? It's on a 65 Barracuda 273 a833 4spd. Thanks.

Any pros/cons on this intake manifold? I am planning on using on 318 8.5 to 1 compression, comtetition cam solid lift magnum 270 for street driving. Also there are some china knockoffs on ebay, anybody had any experiance with those? Thanks.

Any one know of a way to remove these without breaking? They hold the lower trim piece below the door. Also are there any parts sources for replacements? Thanks.

Wondering if anyone has a set of seat brackets laying around for a 64/65 Barracuda/Valiant/Dart. I only need the angle brackets that attatch to the floor, mine are rusted bad but the sliders are fine. Thanks.

What is a good plug to use on a 318 with standard compression 270 magnum solid com cam older single plane edelbrock with 4 speed in 65 barracuda? I was planing on using Champion 14's. Is that to hot?

New to the site but have been reading posts for a while, time to tap the knowledge. Working on a set of 318 HP heads 1.88/1.60 bought a Fel Pro engine gasket set and it had 8 of one style valve seal and 8 of another with no instructions. Can anyone tell me which is intake and which is exhaust? I...

Looking for good Hood for 65 Valiant/Barracuda. I am located in south western ohio. Thx, Dave. [email protected]