Search results for query: *

  1. A

    Transmission blew in Automatic 65 Barracuda

    I saw your post about your 904. Do you live in Cartersville Ga? I may be able to help you out on rebuilding it if your close to Chattanooga Tn?
  2. A

    904 tranny recipebehind 360

    ^^ I agree... And If you have access to a 998/999 rob the output shaft and thrust washers that come on the front of them. Those shaft have a much better design oil feed hole out the front than the older shafts. They oil the thrust washer that's between the rear clutch drum and output shaft...
  3. A

    Boom goes the......

    A bolt in sprag wont cure the problem. Most sprag failures is from the springs and rollers in the sprag being damaged and rolling over and not locking the low/rev drum from turning. The "ultimate sprag" is a much better design. More springs and rollers in it. But misuse while in 1st gear can...
  4. A

    Help troubleshoot 904? Slipping at higher RPMs

    Jay, Awesome news! Glad thats all it was. :)
  5. A

    Help troubleshoot 904? Slipping at higher RPMs

    Thanks guys! I know i will never get rich building these things, But if im taking money to build someone a trans? I want it right for them. And don't like seeing them come back unless it many many years later? lol Lost one friend a few years ago over a 727 I built for him. It worked and...
  6. A

    Help troubleshoot 904? Slipping at higher RPMs

    Jay, It isn't a problem. Contact me anytime. Having the throttle pressure linkage hooked up wont cause that problem. That lever doesn't operate anything in the manual valvebody. To me you buying it from him is the same as me building it for you. If it's a problem I did? I want and have to make...
  7. A

    Help troubleshoot 904? Slipping at higher RPMs

    Jay, I think that 904 of one of my builds. In 20 + years of building them, That's a first for me hearing slipping problems like that. I can think of a couple things that could cause it. Line pressure like they said. If you drop the pan check to filter to make sure its tight. And check valvebody...
  8. A

    Ok, What have I done now... (904 problem?)

    The gasket goes between the vb and the spacer. I would put it back together and drive it again
  9. A

    TCI Transmission is bad

    $850 to build a 727 is way too much. But that's just my 2 cents worth. Like the other guy said. They aren't hard to build. Can replace all seals, bands, clutches, Steels and bushings for about $150 in parts. I build them for all the mopar drag racers around here. If i can help? Let me know...
Back
Top