Search results for query: *

cool beans!!! thanx oldmanrick and crackedback:prayer: 18degrees initial and she purrs happy now woot woot:burnout: idle is steady at 1000 and vac now at 12 lil jumpy but me thinks that wat my cam is meant to do heheheh can't wait til daylight and i can go for a long cruise

ya if i remember, lol not that my memory is good, we calculated the cr at 9.2:1 during the build. Lol i thought my vacuum was high for this lumpy cam!!! once rings have set and its a lil more broken will/should the vacuum be lower? is there anything that could cause the high vacuum? or am i...

perfect thats the advice i was looking for rick :) I'll def swap in the smallest (number wise) bushing and get some lighter springs to open 'er up faster too. will shoot for the 2800 rpm all in springs. Then i will get my initail timing setup properly then turn my attention to the carb/idle...

the stop bushin only stop the amount of mech advance, the spring stiffness is wat will control the rpm range, so i think the 25 stop bushing miht be ok so i can run intial at 8-10 degrees and if i change to lighter springs the i should be able to get all in at 2200, 2800, 3400, 4000, 4400 or...

oldman i put the higher stop bushing in the dist. stock is 21 which, according to msd, would be all in around 3600rpm. I thought a longer spark advance would keep my power building as i revved up but now i'm thinkin i want all power available at lower rpms too

engine is a 70 cast 318 bored .030 over 4.00" cast scat crank scat I beam connecting rods kb847 pistons 302 ported heads w 360 valves Comp Cams Flat Tappet Mutha' Thumpr Cam, 235i/249e duration @0.050lift, .497i/.483e lift 107 lobe seperation lol I'll tackle the cam bushing and lower, does...

Thansk for the reply 67Dart, I've used this timing light before on this system and another msd equipped 318 with no issus but now, after the sun roasted it, wen i checked the total timing it was erradic and bouncing around on the marks engine seems to run fine but i want to get this dialed in...

Hey Guys n gals i got a fight on my hands lol jus finished getting my 318 stroker installed and running but i can't seem to dial in the timing or carb tune up here goes with what i've done Initial Timing set to 15 degrees Finial timing is 40 at 4800rpm ignition is all msd 6al box...