Search results for query: *

  1. 6-david-5

    Pertronix II/ MSD SS

    First--glad your /6 is running. On my Dart, I run an Ignitor 1 in a points distributor, and it triggers an MSD 6AL that I mounted in the interior of the car--it does not have to be under the hood. I prefer to use an Ignitor as a triggering device and use a good ignition box to drive whatever...
  2. 6-david-5

    Pertronix II/ MSD SS

    So, to make sure, a Pertronix Ignitor II 91361A? I looked at the instructions and they say "can be used w/most ignition coils rated at .6 ohms or greater. I expect if you go lower than that, then you will risk overloading/burning out your ignitor II. Your MSD coil comes in at .35 ohms of...
  3. 6-david-5

    Switch that interrupts the ground circuit

    Krazee That will "work". HOWEVER, here is why I wouldn't do it this way. In this plan, you will be running quite a few amps through the switch, and the quality of your switch will determine how good of a ground you will have for your fuel pump. If you are using a really-good high amp...
  4. 6-david-5

    Voltage Regulator Bypass

    You guys are correct. I did this to my '67 Belvedere using a parts-store alternator for a 1991 Toyota 4Runner 4-cylinder (they have a v-belt pulley). I even spliced the factory wiring into a Toyota repair connector very much like the following: ALTERNATOR REPAIR PLUG HARNESS 3 WIRE PIN...
  5. 6-david-5

    FBO box took a dump. I think

    How are you using the car? Hot street/track use a couple of times a year? I like the 6AL so you have a rev limiter, and you can run almost whatever coil you want (the compatibiltiy list is pretty long!). If you had to replace it, you could visit a Pep Boys/Auto Zone/O'reallys and get another...
  6. 6-david-5

    MSD ignition recomendation...

    The MSD is a nice controller, and I like triggering them directly off a factory magnetic distributor. But your not going to get 20-horsepower worth of difference or anything of that sort--especially if your car is already running fine. It will smooth out the idle and the rest of the entire...
  7. 6-david-5

    Denso Alternator conversion Part-Number ?

    ............. I JUST completed this swap on my big block Belvedere. Here's what I did: Show up at your local VatoZone (or your favorite chain parts store, whatever it may be). Ask for an alternator for a 1991 Toyota 4Runner with a 2.4L 4 CYL--THIS is important because that is how you get...
Back
Top