Search results for query: *

Double check ALL your ground straps

Hey 67dart is there any particular reason you are not running a constant hot thru a relay. I ask cause I seen the diagram dan made on .org site and he has one .

Thank you guys for the help voltage reg shot coil was fine And I will be doin the hei conversion

I think I got it

Now we can scratch our heads at the same view

Ok and once more Still running 14.6 at the bat. And then progressively less down the line

Ok so here's the news so far checked and kleened all straps and grounding surfsaces New condenser and points another multimeter and checked for good continuity Car is running now tests goin in to resistor 12.5 goin out 10.5 at coil 9 Car will run at high idleand low idle for...

Well I called a friend who does ag mechanics and he told new that he's installed new points and condensers, and had the condensers end up junk right off the shelf. If I'm burning them up driving it's the condenser that is bad. There its no cushion for the points. He said the ballast...

Ok I got some numbers at the coil it reads as low as 12.22 and as high as 14.39 but I did see a few spikes as high as 16

And just for reference I've driven the car around the neighborhood no problems for up to 15 minutes at a time"several times" The car has idled in drive way for up to 30 minutes the last time I drove it ran great excellent throttle response cruised nice really enjoyable, but after...

The petronix started cutting out on my way home from work goin down the road at 55mph out would just fall on it's face I would lift the throttle and out would come back to life would go a few miles problem free, and then start the process all over again til no more vroom vroom I...

1.2 in the coil .6 in the test leads

The time line for this is from install to almost home from work"25 miles" All new parts short of distributor Have meter in hand off work headed for new parts will let you know what I find out

How's it goin I'm new here to this so here we goo I have 65 valiant 225 and I've burnt up two sets of point and a petronix set I've double check a much as I could new ballast Any guess's in what could be the issue My guess right now is voltage reg it has been replaced recently but you...