Search results for query: *

It does say R or L on the end of the bars. As stated usually the numbered end with R or L designation and I always put the identification in the back easy to see. Keep in mind R or L means your R or L as if you were seated in the car looking down.

Rod7515 A quote of $125.00 for all the anodizing work you specified seems extremely cheap. I’d be skeptical of quality. Carl

I had my rear trunk finish panel for my 67 Dart GT done by “King of Trim” I think out of Cali. Wasn’t cheap but reasonable when I priced around. They specialize in bright dip anodizing which is how that part originally was produced then painted. It was completed within 4 weeks and was...

Hey everyone I figured I would throw something out their because I'm not that we'll versed in first generation darts. Is it accurate to assume that 65 and 66 hi po 4 barrel 273 4 speed cars usually came with 8 3/4 and 10" drum unless owner specified different on order form? I though most not...

I thought the original 273 hi-po or 383 shroud on a 67 dart or barracuda was 2785312 one yr only and hard to find. The shroud for a 68 or 69 340 and 383 was 2785614 easier to find. Am I right? Anyone. Carl

Why not get the car dyno tuned using a chassis dyno. I had my car dyno tuned and they measured the exhaust gases and air fuel mixture. By doing this you will enable the engine to run properly at idle as well as under load. It may cost about the same as purchasing a cat and the car will perform...