Search results for query: *

Solve header problems once and for all,half the size,half the weight,mrmopartech https://www.borgeson.com/xcart/product.php?productid=1748

I have a set of 68-69HP manifolds if you need them,mrmopartech

Richard,when installing a large motor into a car and clearance is a factor,there are two rules of thumb.1)fit the part to the car.2)fit the car to the part.Now this becomes a big issue if you have just spent a G note on a set of hemi headers to fit a dart,and have to refit them to clear,Don,t...

The manifolds decode as this: 2843992 LH 68-69 B body 383/440-4bbl HP 2806900 RH 67-8-9 B&C body 383/440-4bbl HP mrmopartech

Two options,use a AAR cuda muffler to do this,or use two 90 degree bends to come out of the back of the muffler and come back forward with the zommies attatched,mrmopartech [email protected] 450 424 0445

Are they up for sale? If so how much,Mrmopartech

They go in from the bottom and the passenger side is the easiest to do and is a no brainer,the drivers side is a little tricky,so I would do the drivers side first and finish with the passenger side.Loosen the engine mounts to be able to lift and tilt the motor to place the headers...

If you are looking for the ideal location,its about at the end on the tranny tail housing.Its after the collectors and the reducers and is in the 2.5inch tubing and is not to close to the mufflers.Mrmopartech

http://www.geocities.com/lars_an_artist/durango.html Take a good look and you can machine down the flanges and increase the clearance,Mrmopartech

You might have to spend the bucks for the right sensor.Problem 1) is it a 1,2,3,4 wire heated sensor,2) does it show in the paper work you have about how many cross counts it needs per second to operate?3) after market sensors are not as good as OEM,they tend to be slower than the OEM.In most...

The casting number is correct,Mrmopartech

dave,did I read it right,your horny for a set of purple headers?dave,please tell me your not on the bottle again,Mrmopartech

The mini starter is a dakota starter for a V6/V8 and can be used on all mopars.I have one on each of my cars and a few spares to be sure.Its a nippendenso starter,gear reduction type,half the size ,half the weight.You can pick them up at the rebuilders for about 125-150can.Mrmopartech in...

If you do not mind doig some work,you buy B-body headers and install the right side with no problem.The left side you need to redo the number 7 cylinder tube to fit the car.It could take you may be a few hours and its done.The headers are about 150$plus what ever time and welding you do,instead...