Search results for query: *

I ran verticle gates and super shifter 3's for years. Sounds like your throw stops are adjusted to tight. That will make a stock tranny drop out of gear. 1 shifter does the other don't. Rick

mshred, PM is welcome anytime. We just scratched the surface info. These setup tips even work for those other 2 brands. The other areas for good solid shifting are critical too. They are, from the engine back. Everything needs to be square, perpandicular, and inline. That includes, main case...

mshred, I forgot to mention the over throw stop bolts. Back them off before you start. Adjust the complete shifter without them FIRST. Make shure everything works smooth and how you want it. Then to adjust the over throw stop bolts, hold the shifter handle snug in gear and turn the bolt on...

mshred, If you look at the shifter body, you will see a 1/4" hole low center going thru the shifter body and both levers. What it does is pins the 1-2,3-4 levers togather and centered in the shifter body. Sometimes it is called "shifter center". Most all Mr Gasket and Hurst have these...

matthon, Sorry it took me a while to get back to you here. The casting # 2468372 is what is on mine. It is the original as I was the first one to unbolt it from the factory. The other casting #2536945 may also be correct and just from a different foundry? So the first one is the original for my...

kempkan. Nice swap you are do'in. Works very well. You have have air trapped in your hydrolic system would be my forst guess. Hydrolic clutches and motorcycle front brakes have become very hard to bleed for about the last 10 yrs. Reason-- the viscosity of the fluid has been changed for the fancy...

I might have a explain'ation for some of this. I have built a lot of tranny's for muscle car guy's before I retired my shop for health reasons. Other than M21 M22 Muncies with the bellhousing face machined out of square with the main shaft. 34 to be axact. This happened to 2-833's and 1-T10bent...

Morning All, I worked on these shifters for guy's a bunch 30 yrs ago. As They could not get them to shift right.They said "I used the pin like the directions said and they work great at the track but can't shift it at all on the street" What I found was One rod (I think 3-4) needed to be turned...

I know you are mostly talk'in small blocks here. Just to add some to this to help clear some ideas. 4.25" stroke 440 18spline 833 in a 3100lb 69 dart 4.10 to 4.89 gear. have both. 90% drag 10% trip to the drive in. What flywheel lb would you run? Mid rpm solid roller cam, med size port aluminum...

matthon, I have an original that came out of an untouched 67 383 formula S Cuda. When I get home middle of next week I will get it out and see if it has a casting # for you. I am working up in Colorado so I am 300 miles from home. I have almost all the parts for the car but the body. The car...