Search results for query: *

Southeast Gassers B-Gas 366 C.I.

Thanks I’ll look into them

Honestly, they didn’t know for sure and were suprised I found one. They said they made them primarily for Indy cars in the 60’s. Then melted the leftovers to make small block chevy units. Might have been messing with me, but with the amount of SBC ones floating around I wouldn’t doubt it.

It’s a small block chrysler hilborn, took me 12 years to find one. I spoke with Hilborn at the PRI show in Indy and they said they only made a few hundred, and melted a lot of them back down. Probably would be easier if I was running alcohol but I’m making progress.

Yes just to roll it around...it has 4.5 Chevy bolt pattern to open up wheel options. I have the slicks on matching slots

Pics of the car. Small block injected 4-speed on gas. Should be ready to make its first test hits within the week. The Hilborn has been a challenge.

I've already removed and installed. It wasn't the funnest job but not terrible either. Like I said, I really want to get rid of the front due to fogging, the sides to increase weight savings, and figured I'd throw in the rear for good measure. The vintage rules don't want to see modern support...

drag only car picture in sig, looking at options to get to a #/ ci class designation front glass is fogged between the laminations so I'd like to replace it. just figured I'd go all the way

So you made your own by heating it over the stock piece? I heard about that being an option but figured it would be slightly to big as the inside glass dimensions are now the outside of the stock piece. Is the flexibility what makes this a non issue? Did you only use the stock rubber molding...

Anyone install a rear lexan window in an early Barracuda? If so, where did you get it and was it a royal pain to install?