Search results for query: *

thanks mike, i'll get back to you later.

my truck is a 81 dodge 250 and the floor mounted high low foot switch is rusted out, soooo no lights, makes for tricky night driving.

ha, i see what you mean. it's the bulb socket, the part the bulb goes into with a 2 wire connector and a ground wire. the front one on the right side of the grill.

mine melted in a fire a few years back.

did you go on vacation?

interested. I sent a pm.

15 x 9 with 7" bs and 4.5" bc.

I have got one, thanks for the replies.

complete 71 dodge demon engine compartment and front harness.

two 3/8" x 1.5" x 7* double spring steel retainers

thanks, i e-mailed him.

in good condition.

in fairly good condition. i'm in warrenton, nc 27589

for mechanical rocker gear and hydraulic lifters. pm me or earthmover. i reckon if no one had puch rods maybe one of you has push rods.

i sent you a pm yesterday, thanks for the responce

looking for the 4 bolts that hold the fuel bowls on that have a metering block and a 50cc pump housing and the spring that goes inside it. also 2 idle adjusting screw.

thanks for the heads-up

looking for 4 of the rear clutch disc. these are about .061" thick.

looking for a set 15" x 9" with 7" of back spacing with standard mopar lug pattern.

used is find but i'm looking for at least 6 sets, 12 halves.

me. $10+shipping

need 1 good used fitting to finish the return lines on my demon.

thanks for the number. but was hoping some one would have one laying around.

need bronze big block drives worn out were the gear meets the bushing in the block.