Search results for query: *

I never re torque my 340 but I did not use to steel shim, still don't think it matter..in fact the steel will less likely compress and lose torque I did blow a head gasket once going flat out and it turns out the other head bolts were not at 80 or more lbs, more like 50 it felt like....but I...

Its only low compression, what is the worry ? I could see if its was a racing 13 to 1 engine and even then if iron heads it still might not be needed

For more stock engines / ignitions maybe these I would try http://www.summitracing.com/parts/NGK-4563/

Yes ,dielectric grease is a must. I believe in non resistor plugs and smaller gaps, no .050 plus Have an MSD 7 al box firing these plugs, they stay clean but wear out, gap at .035 and replace when the gap grows to .045 - .050 http://www.summitracing.com/parts/NGK-7173/

Don't forget to put a heavier wire from the alt to the battery When I put my stereo amps in I seen good advice about using a 8 gauge or larger cable from the alt to the battery. * gauge was bare min and look whats on there now. I left the factory wire and just added an 8 gauge wire and extra...