Search results for query: *

Slid this into my 68 ragtop.

I had my air gap clear powder coated about 10 years ago. I has held up very well and has not yellowed at all and no gas stains either. I think the only drawback is it holds the heat more than when uncoated and that transfers the heat to the carb. You will want to run a heat shield an phenolic...

You mentioned you have a new drive shaft, did you get it made the same size as the one it replaced or did you measure it and get one made to suit? A half inch shorter than it should be will have the same symptom you describe.

My 66 Cuda's bullet.

For whatever its worth I run the same cam with the Hughes lifters, lots of hard miles and no problems at all.

Yeah he might! I just read the article and found out the Mystery Motor was in fact an IIS 427 engine according to the author of the article. It was quite an engine development program they had going on there."Truth be told, Dick Keinath had a hand in every modern Chevrolet engine from four...

Thanks for passing along Websters definitions of a motor, it confirms the original posters picture with the word "engine" may if fact be correct. Not sure how they came up with the name Atlanta Motor Speedway or General Motors came up with their name but interestingly enough I was on General...

It's actually a photograph of an engine and automatic transmission. I think motors are electric. This looks like an internal combustion engine possibly made to be installed in an right hand drive Australian produced Chrysler powered vehicle post 1966.

I have seen this before somewhere, Australian right hand drive a per 66340SEDAN'S comments, motor mount 67 and up also.

I run a Comp Cams hydraulic roller with the Hughes lifters and run Mobil 1 15/40 synthetic, working great so far.

Well I will tell you this, I am a die hard Mopar guy through and through and have been involved in alcohol winged ashpalt sprint cars and Mopar engines were just to cost prohibitive to run. We have like almost every one else run the small block Chev, our 650HP cast iron dry sump engines complete...

Yes but it was just rebuilt by a "HIGH QUALITY LOCAL ENGINE BUILDER" !!

I have 2 sets of these about 10 years apart in age, both had guide problems, both sets had some tight ones, one set had 4 very tight ones and 2 very loose ones to the point it was smoking. I would have to say that given the born date of these two sets they are notorious for guide problems. My...

I have had Dougs on my car for about 15 years, I have power steering and a 5 speed and they clear everything just fine. I have a mini starter and run .1.14 torsion bars and they are snug around these but they fit great. I highly recommend these for your application over fenderwell headers.

I would have to say as mentioned above I agree that the cam timing and ignition timing sound out and the obvious lack of gearing with that tire choice. One other thing you might want to look at that as dumb as it sounds, is it really getting wide open throttle. I think we have all seen this...

True enough, they also came with bias ply tires and 4 wheel drum brakes but last time i checked it is now 2015 not 1964 and things have changed a bit so why not go with some upgrades to make your ride a bit more user friendly not to mention the price of gas has gone up just a touch since back in...

Better get on the Passon 5 speed waiting list, that would help you in the rev department!