Search results for query: *

Re bleed 'em. It's free.

If you grind off the head of the bolt, there is nothing holding the cylinder on. The threaded portion will still be stuck in the cylinder that you are gonna toss anyway.

I back the adjuster all the way off when assembling them. Hook the adjuster cable bottom to the cam lever or whatever its called, then take a small screwdriver and pry it onto the guide. Minimal force is used.

Cool.You should be able to get drums shoes and wheel cylinders for about a hundred bucks. Not sure what the spring kits go for but I'm sure they cant be too much. Luke

Measure you drum inside diameter, and the width of your brake shoe. On my 8 and a quarter I gave the parts house those dimensions and as it turns out they were for a 70 charger. My brakes are 10 inch dia by 2 and a half wide shoes. Luke

Hey fellas, Got into my rear brakes today to put in some longer wheel studs. The car is a 69 barracuda notch with an 8 and a quarter 10 bolt in it BBP. How can I get the correct parts to do the brakes or rather what vehicle do you think it came out of. The tag says 3.21 (gear ratio) I assume...

The low fluid is being caused by the cap not being clamped down enough because the bail is shot.

Sorry for the big pic. LOL Fixed it

I think that I have a proportioning valve. Would you guys agree ??

I saw that afterwards. No worries.

How about the valve ? What does a drum drum valve look like compared to a drum disc valve ?

As discovered in my earlier brake thread It appears that the 73 up BBP front disc brake has been done to my car. It was questioned if the right master cylinder and proportioning valve were installed as well. Here's a pic of the master cylinder and I think it's not the right one. Here's a...

So your saying that my upper control arm is from a 73 a body as well. Ill get a pic of the lower arm and master cylinder as well. Luke

Okay so my next question would be, If 73 duster parts would work, would a master cylinder of the same car work ? I have disc front and drum rear non power brakes. i can put up a pic tomorrow of the existing master cylinder tomorrow to help in the identification. Sorry I'm a newb to the mopar...

would there be a date code on the caliper or rotor ?

I'm just trying to figure out if my 69 barracuda disc brakes are factory. The rotor has the chrysler star on it. and the best I can measure the bolt pattern is 4 and a quarter inches.