Search results for query: *

Just checking ,did you remove the choke stat from the manifold? My 1406 wouldn't set flat , it was on the edge of stat. plate.

I can't remember its been over 40 years since worked at dealership on those carbs.

That is the correct Port but fuel is not getting to that circuit for some reason, with mixture screw set throttle plates sould be just barely open at idle, and mixture screw should very idle speed from lean to rich.

You have the throttle plates opened up to transition point so I just pulls just enough fuel to run. The idle circuit opening is a small hole inside the Venturi of the carb below the plates when closed, This is what is plugged, it can't get fuel to run on with idle adjustment screw backed out...

The bottom of the bown vent rod is activated buy the large flat washer on the curb idle screw. At idle the washer will hold pressure on the end of the rod holding the vent just barely open, when you open the throttle the washer moves away from the rod letting the vent close on the bowl. Idle...