Search results for query: *

I'm all set on the balance differences and want to locate a B&M for the SFI rating.

PM if you have a reasonably priced flex plate.

looking for a 727 GV tailshaft adapter. Thanks for help.

Yes Edelbrock Performer RPM Air-Gap Intake Manifolds 7577

FYI the M1 I had and sold off a 300hp Magnum crate motor was not off set. I hope this helps.

Has anyone used these? Do they have needle bearings on the shaft?

Agree and since the idler arm is a one year only part it's expensive

Lunati ground a custom hyd roller for my car 234/236 @50 495/475 lift 108/106ICL for $310 shipped. It's a steel core so I can run an iron dizzy gear. When I spoke with Oregon it had to be billet with a bronze gear due to the cores he had. I'm sure Lunati could copy that grind or get very close...

PM sent.

OK I'm looking for a long snout roller cam to upgrade a 300HP Magnum crate motor. Current cam @050 205/196. lift 420/420 and is done at 5k rpm. I spoke with bullet cams about regrind, approx 2 week turn around. Figured I'd post a wanted ad and see if someone had a good performance roller cam...

Looking for a hyd roller cam to upgrade a 360/300hp mopar crate engine.

I need a passenger side inner fender splash shield for a 69 Dart, the shield aft of the front tire. I'm sure other Dart years will fit but I don't know what years interchange. Thanks.

Those won't work on the motor. Need the larger plastic bushing with the 3 tabs and a slip on washer clip.

Why not just make some?

Try Ace hardware. They carry an assortment of plugs in the small hardware section.

Need a known straight driveshaft 45.6" C to C 7260 small u joint, I'm in Melbourne FL. and will be going to the Mopars of Brevard Car show/swap meet this Saturday. Thanks for the add FABO.

I have the 3671918 Intake. Shipping will be $$ from FL.

Looks like those are an upgraded one piece side gear. Cass is at SEMA so i'll have to wait until next week.

Will do, thanks for the heads up. Have not heard from anyone and Dr Diff is out of stock.

looking for a good side gear for an OEM Mopar 8.75 clutch type sure grip.

Looking for a good 8 3/4 clutch type sure grip unit.

I have a 73 A body MP suregrip 3.21 8 1/4 drum to drum with less than 10K miles since overhaul. Everything except the gear set and axles was replaced. Unit is a good one, I'm upgrading to a B body 8 3/4 in a few weeks and will put it up for sale after the swap. PM me if interested, I'm 2 hours...

Need a straight driveshaft 46" C to C for 73 Dart Sport/Duster 108" wheelbase, 727/8.25 rear. 7260 small u joint, 727 29 spline slip yoke. I'm in Melbourne FL. Thanks for the add FABO.

I have a set of 8920s that were removed from a 67 318 I bought from another FABO member. Recent valve job, guides are good, 1.75 int valves backcut, 1.5 ext valves. I'm in FL.

Ace Hardware store has them.

If there NPT go to a marine supply store.

salvage yard. 70 80 90s van or pickups have them.

looking for a good windshield. Will be traveling from Florida to South Dakota this summer so local pickup is a possibility. Thanks for any help.

Thanks Sedanman I wish you were closer. Hopefully Roy will have a good one for me.

looking for someone parting out, I'm in Florida. thanks