Search results for query: *

Thanks all I worked the problem out it has a regular 727 with a regular yolk and no break mounted. I just took the drive shaft to a shop and had it cut. Went to napa and bought a u joint that was 2 different sizes. The rearend is a 8 3/4, the shaft was for a old 7 1/4 but it all worked out...

Tip to tip counting the yolk it's 52"

Hello Guys This may be a dumb question but here goes. Do all 727 transmissions have the same tail shaft? If not what sizes and lengths do they come in? I have a 74 duster with a 360 and a 727 that came out of a dodge r//v. I've installed a 8 3/4 suregrip and I now need to get a drive...

All right guys I need an expert on this one. I'm puttint a 360 into a formally 6 cyl 1974 duster. I've got a 727 automatic behind the 360. The motor I bought had a brace on the drivers side by the starter that goes from the lower part of the transmission bell housing up to about midway on the...

Hello Thanks for the reply. The flexplate I bought on ebay just has some stamping on it. It is 360 sfi pep-fwfp 360 for 71 thru 92 360 motors. It is new not used. It doesn't have any balance weithts on it. Just a cut out spot like a half moon around the edge. I have a stoc converter out...

Hi guys I'm new to this site so if I don't follow proceedure correct me. I have a built 1978 360 truck engine that is assembeled and ready to go in my 74 duster. I'm removing a 318 that has a 727 transmission in it. The 318 and trans are 1976 out of a camper.The Question is. Can I resuse...