Search results for query: *

I had to cut the tunnel up a bit, still was a tight fit

thanks

trans to driveshaft

I have a 73 scamp with a 833 4speed and a gear vendor overdrive I'm going to get the driveshaft shortened I need to know what the driveshaft angle should be. I bought the inclinometer tool to do the job. just need to know what to set the angle at.

I put this oil filter relocation kit in and now i have a new problem, the adapter is about a 1 1/2" away from the exhust pipe does anyone make any angled fittings ?

i bought a 489 case with the caps, and was wondering if the 1 7/8 " pinion stem gear is correct for this unit. as always thanks

3:91

hope this helps

how can i tell, what do i look for ?

i purchased a 489 housing with the caps. i want to purchase a bearing overhall kit, however when i went on the yukon site the stated there were two types of carrier bearings. LM104912/49 AND 25520190 how can i tell which kit to use ?

i have a 73 scamp with a small block, 4 speed trans, 3:91 sure grip rear and im running 245/60/15 tires on the rear. its quick ff the line but when im on the highway im doing 4000 rpm ay 60 miles an hour. what ratio would be good off the line and decent on the highway ?