Search results for query: *

Bump

Bump

Pulled from a mismatch in a 69 Charger 44" spring perch centers Open carrier Not sure of ratio $400 Pickup near Scranton, Pa 18508

46" perch centers. Backing plates for 11" brakes Axles with new green bearings installed $600 pickup near Scranton, Pa 18508

New Melling 3-495S Timing Set 25$ + shipping From 18411 Cash, Venmo, Money Order

Set of SBI small block ir /6 valve springs. Count is 12. $30 + shipping From 18411

$75 plus shipping

Dropped to $90

Set of 2.76 gears from a 742 case. 110$ plus shipping. Located in 18411. Paypal f&f or postal money order.

I have what I believe is a 360 motor home engine from thw early 70s. Oddly enough there is no casting number on the block. Its a 2 barrel. For sale is the throttle bracket with kickdown linkage, throttle cable is unuseable. $50 + shipping from 18411

2 barrel intake manifold for 1968 318 engine. Pulled from 68 barracuda. $45 plus shipping. Scranton, PA

bump

Still available.

Never ran or installed.Hardware is 99% here. Late A-body spindles from Magnumforce racing. A little s**t stained from sitting around for a while. Could easily sell for a boat load more if we all werent so poor and cheep around here. At $350 bucks this is a steal. Buyer pays shipping...no deal...

Lower control arms off a 1968 Barracuda. Modified for front coil over setup. Firm-feel greasable pivot pins and poly bushings have been drilled and tapped to secure end plates for bushing retention. Reinforcing plates are welded on and original torsion bar tensioners are welded as well. Will...

bump

bump

bump

bump

bump

ill keep that in mind if they dont go.

Upper control arms are not included. Without the spindles this is the regular kit from wilwood for converting your front drum setup to disc. It includes the hubs and bearings, rotors, calipers, brake pads and all the hardware to mount them to the stock a-body drum spindles. There are two...

sOLD

bump

bump

bump

Located in 18508 Installed but never used. Never had fluid added. Dynalite conversion Asking 650$ Will throw in pre-drilled big ball join spindles pictured with brakes for an additional $400. PM me and we can make a deal.

Sold

Not sure. Im gonna venture a guess and say maybe...i used them to mock up a front end setup so i already had the lowers off.

location 18508 I'm asking $450. The firmfeel greaseable pins and poly bushings with zero miles on them are alone worth $135. All torsion bar adjusters welded. Reinforcement plates welded on. Pins drilled and capped for bushing retention. Buyer pays shipping no deals.