Search results for query: *

If a person doesnt have a full 12 volts going to an electronic oil pressure sending unit, will the pressure readings be off a little or a lot? Or does it make any difference if the voltage is a little low?

After reinstalling engine and accessories- minus a/c- I am in a pickle as to placement of powersteering pump belt. Pulley seems to line up inbetween double pulleys on crank pulley.Does the ps belt run off of furtherst pully out groove or second one in from front? I replaced the leaking ps pump...

I am trying to get 360 set down on the kframe in my 72 Dart.I have one thick rubber pad and one thin rubber pad.I have the thin one on driver side and the thick one on the passenger side,but the engine doesnt seem to want to set down on the frame on the passenger side. Can anyone tell me how...

I tried to install my 360 into my 72 Dart this evening. I have a Milidon 8 qt. oil pan [ 30940] on it,and I cant seem to get it to clear the k frame is it a really close fit?.I also need some help with motor mounts. Does anyone have any photos of correctly installed motor mounts.I bought a mt...

Hey guys I have a rebuilt/ and internally balanced 360 I am about to install in my 72 Dart. I had trans. rebuilt with shift kit,also bought new torque conv. with 360 external balance.Am I about to have a problem with balance? Since balance on conv.would offset internal balance.

I have been informed that the 360 oil pan I bought on Ebay is strictly for a 360 out of a car.I got my 360 out of a van,so I need a center sump pan to fit the engine so it will fit in a 72 Dart. Where might a fellow get one? Thanks Dale :glasses6:

Bought a 360 chrome oil pan off ebay,was supposed to be for a car 360,however the pan will not fit at back of engine.It is to small to fully set down on the block.It hits the rear seal long before it mates to the block.Shows to be about 1/4 inch to small.Is this a pan for a 318/340? I need to...

What would be a good roller cam to put in place of a stock roller cam?I want something that has a noticable lope.It is a daily driver to and from work.I am not interested in racing,I just want it to sound cool.Also what springs? It is completly stock,no headers,but will use air gap intake,4...

Hey guys, I have read all the posts about motor mounts,and believe it or not I am still perplexed over my engine swap.I pulled the motor mounts from my 1972 Dart 318,went to mount them on my 1989 360 [which came from a 3/4 ton van for FREE],they dont seem to fit.I was going to make a spacer for...