Search results for query: *

Long story short, Not paying attention and knocked a small 1/8 spring washer down into the distributor /oil pump hole. ..."Oil pump drive was out as well". Can this washer cause problems by getting into the oil galleys or will it drop down past the camshaft into the oil pan, as per attached pic...

Recently did a full rebuild in my 360…. I put Manley S/S. Chevy 2.02 / 1.6 valves in which have a .100” longer stem. As a result, I had to measure and order custom pushrods. Comp Cams camshaft and lifters. Ran the cam in no probs as per the book and runs beautifully. Oil is 65 at startup and...

I have a chrome dress up after market dipstick on my 360SB dipstick reads FULL (cold) but i drained the oilpan and only have 3 litres in it?? any ideas??

I am in the process of installing new cork side gaskets and rubber end seals in my LA 360. I have a couple questions. I notice that the cork gaskets protrude past the point where front and rear seals sit. Do they need to be trimmed to fit.? If not which end should overlap/underlap ...Front...

I have to notch the oil pan on my 360sb. In order to fit rack and pinion p/steer rack. I need to get around 10mm clearance between rack and notch tunnel. I have fitted a pair of 6mm spacers on the engine mounts , but still probably need about the same again to give the desired clearance. . Is...

I'm not sure which of the 2 fittings on the sandwich plate supplies oil to the remote filter and which is the return line fitting. Can someone point me in the right direction here?? Thanks

do these flexplate to converter bolts have washers of any description, or do the bolts just get torqued up with loctite and no washers...Have seen somewhere some type of star washers with these???

Can someone tell me the min clearance specification for oil pump to crankshaft. I only have .020 and seem to remember reading somewhere that it should be up around .060 :banghead: