Search results for query: *

Is the bolt pattern the same on a small block and a hemi crank pulley? Reason, I bought a damper from Innovators West based on the advice here to get the best I could considering stroker changes everything etc. I found CFV crank pulley that's the right height or offset, but they only offer it...

I think it was here on FABO that I saw mention of a few machine shops, one of which included Moonshine Speed Shop. Just south of Greensboro NC, they are a bit far from me, but I wanted to check them out because I wasn’t thrilled with the look of the shop near me. Super nice folks, took time to...

I cleaned up the passages in my oil pump and block. I need a new cap for the oil pressure spring, but I don't need to purchase a new high pressure spring kit. Does anybody know where to get just the plug. I have done searches here and find many mentions of the plug, but not where to get one...

I hate to ask questions that might make me look stupid, but here goes. This is my first go around with getting this deep into an engine. I’ve changed oil pumps, had the heads off, changed intakes and the like. What I don’t have practical knowledge about is the machine work. Why is it standard...

I saw these on FB. Crazy huh? Naimo Composites Developing LS Carbon Fiber Connecting Rods

You-All here on FABO supplied lots of inspiration and help with the body/sheetmetal part of my project. As that part of the car starts to transition to being ready for paint, its getting closer to the stage of needing the engine done. I have been apprehensive about building my own engine, and...

I'm sorry for the Wall-O-Text. I want to start putting together a plan for the motor for my 68 Dart project. I currently have a 340/833 that I ran on the street from 88 to about 2001. It ran strong, but I have no idea of its history or specs. Then it was parked. I occasionally shot WD-40 in...