Search results for query: *

Any body know what the length is on a positive battery cable for a 70 Duster small block is . Or where to get cheapest nos one .

Need help with coil resistance. Have a 65 barracuda slant six car that i believe has been converted to a electronic ignition.It still has resister mounted and wired up on fire wall the resistance on it is around 1.9 ohms unwired. The coil has 2.2 ohms resistance unwired is this the correct...

Has anyone converted there h4 headlights to led. Can you just replace the bulbs with led bulbs. Or do you replace the whole light. Where can you buy the bulbs or light

Sometimes when i start my car the starter makes a very very loud clunking noise. It is a 1973 727 transmission with a mini high torque starter.I do not have the dust cover on it.I do not know if that would make any difference since this may space it outward out of the ring gear teeth.I have...

Do any members or any companies make a plate to limit the travel of the vacuum advance canister arm on a msd 8388 distributor.Thanks

I have a mech advance distributor with a 6 al box installed in the car now.I am going to install the 8388 ready to run distributor.Can i run the 8388 with the 6al box and what would you do about the rev limiter.Also how would you wire it.Thanks

Looking for a 8388 msd dist for small block that has the vac advance. Also looking for 6 pak bolt on hood 70 duster

Can you buy front marker light assembly.I have new lens but am missing one of my front marker light assembly with electrical plug?These are for 70 duster

Where can i purchase different size bushing that limits the mech adv other than what comes with there kits

I have the original headlight switch out of my 70 duster.The terminals are labeled b1,p, r,b2 which i broke off,h,i,and d.Can anyone tell me what wires go on these terminals.

Can you purchase new bulbs for your dash.Anyone have a photo of the back of the cluster so i can see locations of bulbs.Hard to see them with cluster installed.And does anyone know what the part number is for the bulbs

I have original wiring harness in my 70 duster that originally had points.I am installing a msd 6al box with msd dist.I am removing the resistor.Should these 2 wires be tied together and ran to the red wire on msd box for the 12v switched

Getting ready to install msd 6al box in 70 duster.Car originally had points ignition.Can anyone tell me what i need to do to wire this up.Thanks

I am wanting to mount my msd box under the battery tray in my 70 duster.Any one have any pics how they did theres.Did you have to remove and leave off the bracket that goes on the battery tray

I have a 3 prong neutral safety switch on a 727 trans.How can you bench test this with ohm meter.Does it matter which way the plug goes on.