Search results for query: *

Pulled from a mismatch in a 69 Charger 44" spring perch centers Open carrier Not sure of ratio $400 Pickup near Scranton, Pa 18508

46" perch centers. Backing plates for 11" brakes Axles with new green bearings installed $600 pickup near Scranton, Pa 18508

New Melling 3-495S Timing Set 25$ + shipping From 18411 Cash, Venmo, Money Order

Set of SBI small block ir /6 valve springs. Count is 12. $30 + shipping From 18411

Set of 2.76 gears from a 742 case. 110$ plus shipping. Located in 18411. Paypal f&f or postal money order.

I have what I believe is a 360 motor home engine from thw early 70s. Oddly enough there is no casting number on the block. Its a 2 barrel. For sale is the throttle bracket with kickdown linkage, throttle cable is unuseable. $50 + shipping from 18411

2 barrel intake manifold for 1968 318 engine. Pulled from 68 barracuda. $45 plus shipping. Scranton, PA

Never ran or installed.Hardware is 99% here. Late A-body spindles from Magnumforce racing. A little s**t stained from sitting around for a while. Could easily sell for a boat load more if we all werent so poor and cheep around here. At $350 bucks this is a steal. Buyer pays shipping...no deal...

Lower control arms off a 1968 Barracuda. Modified for front coil over setup. Firm-feel greasable pivot pins and poly bushings have been drilled and tapped to secure end plates for bushing retention. Reinforcing plates are welded on and original torsion bar tensioners are welded as well. Will...

Located in 18508 Installed but never used. Never had fluid added. Dynalite conversion Asking 650$ Will throw in pre-drilled big ball join spindles pictured with brakes for an additional $400. PM me and we can make a deal.

location 18508 I'm asking $450. The firmfeel greaseable pins and poly bushings with zero miles on them are alone worth $135. All torsion bar adjusters welded. Reinforcement plates welded on. Pins drilled and capped for bushing retention. Buyer pays shipping no deals.

Located in 18508 Asking 135$.They sell for over $200 brand new. They've been laying around for months. Buyer pays shipping,no deals.

Located in 18508. Includes camber/caster kits Moog ball joints installed,but may need replacing have sat without grease fittings for a few years. These usually sell for 350$ or more without camber kits or ball joints and without powder coating. Im asking $300...buy pays shipping and Im not...

Black finish Mopar Performance valce covers. Fit LA series small block. Never used as you can see from the pics. Just a little dusty. $65 plus shipping PA 18508

Fit 3" axle $10 18508

Never used Strange Spool with 4.10 richmond gears for 489 8 3/4 case. Bearings are pressed on the carrier and a bearing and .020" shim is in place on the pinion gear. This unit has never been run. its a 30 spline not a 35 like it says in the title Will sell the complete set for 235$ plus...

For small block. Taken out of box and put back in. Going in a different direction. Asking $190. Located in PA zip 18508

Not brand new, but never used...well used in a mock up of a rear suspension. Absolutly zero miles on these puppies. Going in a different direction with the rear suspsension. $200.00 plus shipping. If you're close we can make arrangements to meet if you dont want to pay for shipping. Scranton...