Search results for query: *

Hey all Looking at rebuilding my 8.25 over the winter as it is on it's last legs...Since 8.75's are hard to find and expensive to rebuild I am going to stick with the 8.25 as is should hold up to my street only car. Looking for some advice on part manufacturers... Axles Looking at a set from...

Hey guys I have a 8.25 in my Duster and the axle bearing surfaces are a little scored. I used some repair bearings but it think it is time for some new axles. Where would be the best place to look for some new ones. Most of the big companies only have dakota or durango shafts. Can these...

Hi Guys I am swapping out my /6 for a 360. The engine I obtained had a 727 with it. I know if I keep the 727 I will have to shorten my drive shaft when switching from my current 904, but I have also read that the some of the column shift linkage parts will not fit right. Namely the cross...

Can't find this casting number. I just purchased a 360 with a 727 bolted up to it. There are the numbers 925-1 on the bell housing in big #'s then down on the side is 2466925-1 and A 727 A on the bottom of the bell housing. On the tail shaft there is 2466901. I found reference to the...