Search results for query: *

Does anyone know who would have these clips? They clip to the body of my 65 valiant wagon for the tail light assemblies. I am missing 2 but would prefer to replace all 6 on my freshly painted car. Thanks in advance.

I just picked up my 65 Valiant wagon from paint and I needed a windshield. I checked several places, classic industries, ebaymotors, etc. I came across a place on line called "Windshields to go USA". I put my info in, they gave me a reasonable quote. I picked 1 of their numerous locations close...

Hey everyone, time to have my trunk trim for my 67 dart gt polished and straightened.Can anyone recommend a reputable shop to do this work? I live in s.e. lower Michigan. Thanks in advance.

I'm re assembling my 67 Dart after paint. My passenger side window is missing some parts and I'm not sure what they are called or who sources them. There is a plastic liner that attaches to the front edge of the glass. It has 2 metal sliders on each side of the glass top and bottom that hold the...

Is anyone running their Dart without the chrome around the rear window seal? I am replacing the rear window seal and have been thinking about leaving the chrome off. Kinda wondering how it looks as I plan on doing a blackout theme on my car.

Hey Everyone; I was going to replace my wiper blades on the 66 Cuda and I seem to have lost the blade retaining clip. While removing the clip it shot off to some other parallel universe in my garage never to be seen again. Can anyone tell me where to find one as I have looked on the internet...

I need to repair the rear drivers side roof line by the back window channel on my 72 Dart. I know AMD carries replacement window channel for the corner. I am trying to figure out the best way to fix the rest and maintain the same roof line. Any help will be appreciated.

I need to replace the drivers side quarter panel on my 72 dart. I need some advise on where to cut the old off at. Should I cut below the top body line and try to butt weld the new on and drill out the spot welds inside the door frame and tack the new panel in place? Or should I cut around the...