Search results for query: *

Looking for a NON LEAN BURN air cleaner assembly for a super six /6 2bbl carb... Also need the carb accelerator mounting brackets . Thanks for looking

Looking for a complete Super 6 setup.....manifolds, bracketry, linkages and carb that will work on my 1980, so I need one from that timeframe. Needs to be within driving distance of Pittsburgh.

Looking for speedo pinion gears for 727 auto trans. Looking for 36,37 and 34..... Let me know what you have and how much you want. Paypal for payment. Thanks for looking!

Hi folks I am looking for the little metal tag for the 8 3/4 diff that has the ratio stamped on it, in the 3.55 flavor. ....cant bring myself to pay $16 for a little bitty tag on ebay. Hoping someone has one hanging around they will sell cheap(er). Pay by paypal. Thanks all.

Looking to pull parts together so I can convert my drums to disk... Looking for the "large bearing, short height" spindles from a disk0-brake 73-up a-body or e-body. Big bolt pattern. Let me know what you have and how much, shipped to 15132. Thanks for looking.

I need the secondary linkage rod for a Edelbrock 1407 carb. Not sure if other models use the same rod or what. Thanks folks!

I know I can probably get these new/repro, but thought I would try here first and save some green.... Looking for the trim clips that hold up the metal trim on either side of the car on the headliner....72 Barracuda. I "need" 4 of them at least....I counted 3 broken and one missing...

Looking to get the dust cover/inspection plate cover and the bolts for it for a small block 727. I can pay by paypal. Thanks for looking!

Looking to buy a 3.8 ratio intermediate shift lever for a 727 tranny.... Need asap. I can pay by paypal. Thanks for looking.

Looking for the two square washers/shims used on the rear tranny mount. I can pay by paypal. Thanks! Dave

I need one of the two locating pins found on the back of the 318 engine that aligns/supports the tranny.... Thanks

Looking for: Driveshaft and tranny crossmember for 72 Barracuda that is running an 8 3/4 rear end (2.76 gears , small yoke I thin) and a 1976 318 engine.....planning on the 727 tranny.... Would prefer something local/within driving distance of Pittsburgh, PA. Thanks!

Looking for a good set of floor shift column collars to fit my 72 barracuda. Let me know how much you want, shipped. Thanks!