1968 Plymouth Barracuda

[ReadyRandy]

1968 Plymouth Barracuda fast back not #'s matching 383. Documented by Galen V Govier to be a big block car. Due to economic down fall and loss of garage. I no longer have a place to store my dream. The following is a list of new parts for the car; the engine has the following: bored .030 over, new crank and rod bearings, block and heads have been acid cleaned, heads have been opened all they will go with hardened seats on exhaust, new SS valves, springs, retainers and new locks, a new purple shaft cam from Mopar Performance 484-484, new lifters and push rods, new Edelbrock RPM intake, new carter carb, electronic distributor, and it was rebuilt with a new kit.

Engine: new
chrome oil pan, an alternator, motor mounts, manifold bars, headers, firewall gasket kit, water pump, plugs, wires, thermostat, belts, and aluminum billet pulley kit. Front to rear fuel line (oversized) and fuel pump.

Body and suspension new:
hyper flex suspension kit, TRW ball joints upper and lower, and idler arm.

Interior new:
carpet

Extra: trunk lid, hood, passenger door and glass.
Has owner manual and original deteriorated broadcast sheet.

More pictures on Craigslist posting: http://akroncanton.craigslist.org/atq/2454316400.html


NO TRADES
PM Randy with questions
Akron, OH

Please see rules in place http://www.forabodiesonly.com/mopar/announcement.php?f=41&a=6