For Sale- 1975 Dodge Dart 2dr
Car has been totally disassembled, all sound deadener and under coating has been removed, lower quarter panels have been repaired, both inner and outer. All other rust has been cutout and repaired. The underside of the car has been cleaned, primed, sanded and painted. It has the stock torsion bar front suspension with all new suspension parts. (Ball joints, linkage, etc.) The k-frame has had the engine mounts removed. The car has a 1970
model Duster 1 piece tilt front end it is mounted on the car. The rear package tray and firewall is installed. There is most everything here to get this car running. And a lot of extra stuff included. This was a good solid car to start with and all of the fabrication and welding is first rate.
8 point rollcage installed
Springs relocated 002 003 SS Springs
Weld in frame connectors installed
Custom trunk floor with fuel cell mount
Wheel tubs
All new brake system drums on all 4 wheels, 11 in the rear, 10 in the front
4.5 inch bolt pattern front and rear
Aluminum master cylinder
Line loc installed
#8 stainless fuel line installed
Custom fuel pump and spin on filter mount
Custom seat mounts
Rear wheel well openings stretched to the front 3 inches
Narrowed Dana 60 Truck housing professionally narrowed
All new Strange parts spool axles 4:88 gear All set up will just need to have the perches welded on.
Fresh BB 727- Turbo action reverse manual shifted valve body, 5.1 kickdown lever- good clutches and bands, upgraded pistons and springs
Deep pan
Turbo action Torque converter (New)17505
Freshly machined 383 block, .030 over
Line honed, decked cam bearings installed
Reworked stock steel rod resized, lightened, shot-peened good bolts installed
Speed pro forged pistons installed on the rods - Pistons are new
Its all balanced
Fel-pro overhaul set
2 copper head gaskets
Engle hyd cam grind #K58H, 515 lift (3 bolt)
Engle lifters #862H
Engle springs #833
Edlebrock single plane low deck intake used
1 set bare open chamber steel heads, some porting done, but they need to be finished
1 set of used BME aluminum rods for a 426 Hemi part # 426001 They have been checked and resized by BME with the receipt
PBM 3 bolt timing set #8606
Melling oil pump #M-63HV
Speed pro rings #R-9590-035
Crane push rods #64 672 -16
Hyd for adjustable rockers
Clevite bearings
MS 876 P.10
LB 527 P.10
All of the engine components are new
N.O.S Accel Dual point distributor #37302
4 extra caps
3 rotors
3 points sets
1 cond.
1 super Coil (used)
2 sets of plug wires -New
2 Holley blue fuel pumps - New
3 Holley regulators 2 new 1 Used
16 Imperial electric fan 226116
2 driver F/X seats (used)
Moroso switch panel box - New
Mancini poly spool type trans mount #MRE 4422
Cover lay dash cap #22-402 - New
2 sets Isky adjustable Ductile iron rockers and shafts (used)
4 -15x10 aluminum wheels (used)
2 15x 4 Pacer wheels - New
4 185/80R 15 front tires - New
2 sets of MT cast aluminum valve covers (used)
2 universal drive shaft loops - New
1 set of Hedman headers #78030 - New
1 C.E. Aluminum BB engine plate New
1 C.E. fore and aft travel limiter - New
1 15 gallon fuel cell - New
2 Battery boxes - New
1 Master cutoff switch - New
Positive battery cable New 25ft
75 Aeroquip # 8 aluminum fittings (45s and straight ) fittings are blue and stainless and are all new
1 seven QT oil pan (used)
1 chrome Direct Connection timing cover (Used)
1 400 engine complete used
1 383 short block
1 steel 383 crank
2 BB 727 transmissions - cores
6 cyl. A-body radiator
Front and rear factory bumpers
Original front fenders
All the original glass
1 pair of 70 Duster steel fenders
Steel deck lid
73 and 75 model dart grille and header panel to match
Door handles, window trim, glass, etc.
4 4 x 8 sheets of aluminum for trim etc. still in the plastic.
Extra torsion bars
3 Mopar driveshafts
1 727 yoke
1 set of stock 440 rods and pistons ( used )
1 pair of low back van seats
73 A body A/C heater box
70 A body A/C heater box ( parts )
1 pair M/T 31x10.5 w x 15 slicks - used
N.C Title
Car is located in NC
$4,000 for everything
For photos go to :
http://s861.photobucket.com/albums/ab179/jwmotors/1975 Dodge Dart/
Car has been totally disassembled, all sound deadener and under coating has been removed, lower quarter panels have been repaired, both inner and outer. All other rust has been cutout and repaired. The underside of the car has been cleaned, primed, sanded and painted. It has the stock torsion bar front suspension with all new suspension parts. (Ball joints, linkage, etc.) The k-frame has had the engine mounts removed. The car has a 1970
model Duster 1 piece tilt front end it is mounted on the car. The rear package tray and firewall is installed. There is most everything here to get this car running. And a lot of extra stuff included. This was a good solid car to start with and all of the fabrication and welding is first rate.
8 point rollcage installed
Springs relocated 002 003 SS Springs
Weld in frame connectors installed
Custom trunk floor with fuel cell mount
Wheel tubs
All new brake system drums on all 4 wheels, 11 in the rear, 10 in the front
4.5 inch bolt pattern front and rear
Aluminum master cylinder
Line loc installed
#8 stainless fuel line installed
Custom fuel pump and spin on filter mount
Custom seat mounts
Rear wheel well openings stretched to the front 3 inches
Narrowed Dana 60 Truck housing professionally narrowed
All new Strange parts spool axles 4:88 gear All set up will just need to have the perches welded on.
Fresh BB 727- Turbo action reverse manual shifted valve body, 5.1 kickdown lever- good clutches and bands, upgraded pistons and springs
Deep pan
Turbo action Torque converter (New)17505
Freshly machined 383 block, .030 over
Line honed, decked cam bearings installed
Reworked stock steel rod resized, lightened, shot-peened good bolts installed
Speed pro forged pistons installed on the rods - Pistons are new
Its all balanced
Fel-pro overhaul set
2 copper head gaskets
Engle hyd cam grind #K58H, 515 lift (3 bolt)
Engle lifters #862H
Engle springs #833
Edlebrock single plane low deck intake used
1 set bare open chamber steel heads, some porting done, but they need to be finished
1 set of used BME aluminum rods for a 426 Hemi part # 426001 They have been checked and resized by BME with the receipt
PBM 3 bolt timing set #8606
Melling oil pump #M-63HV
Speed pro rings #R-9590-035
Crane push rods #64 672 -16
Hyd for adjustable rockers
Clevite bearings
MS 876 P.10
LB 527 P.10
All of the engine components are new
N.O.S Accel Dual point distributor #37302
4 extra caps
3 rotors
3 points sets
1 cond.
1 super Coil (used)
2 sets of plug wires -New
2 Holley blue fuel pumps - New
3 Holley regulators 2 new 1 Used
16 Imperial electric fan 226116
2 driver F/X seats (used)
Moroso switch panel box - New
Mancini poly spool type trans mount #MRE 4422
Cover lay dash cap #22-402 - New
2 sets Isky adjustable Ductile iron rockers and shafts (used)
4 -15x10 aluminum wheels (used)
2 15x 4 Pacer wheels - New
4 185/80R 15 front tires - New
2 sets of MT cast aluminum valve covers (used)
2 universal drive shaft loops - New
1 set of Hedman headers #78030 - New
1 C.E. Aluminum BB engine plate New
1 C.E. fore and aft travel limiter - New
1 15 gallon fuel cell - New
2 Battery boxes - New
1 Master cutoff switch - New
Positive battery cable New 25ft
75 Aeroquip # 8 aluminum fittings (45s and straight ) fittings are blue and stainless and are all new
1 seven QT oil pan (used)
1 chrome Direct Connection timing cover (Used)
1 400 engine complete used
1 383 short block
1 steel 383 crank
2 BB 727 transmissions - cores
6 cyl. A-body radiator
Front and rear factory bumpers
Original front fenders
All the original glass
1 pair of 70 Duster steel fenders
Steel deck lid
73 and 75 model dart grille and header panel to match
Door handles, window trim, glass, etc.
4 4 x 8 sheets of aluminum for trim etc. still in the plastic.
Extra torsion bars
3 Mopar driveshafts
1 727 yoke
1 set of stock 440 rods and pistons ( used )
1 pair of low back van seats
73 A body A/C heater box
70 A body A/C heater box ( parts )
1 pair M/T 31x10.5 w x 15 slicks - used
N.C Title
Car is located in NC
$4,000 for everything
For photos go to :
http://s861.photobucket.com/albums/ab179/jwmotors/1975 Dodge Dart/
