318 carb linkage car return and transmission spring stud

[1911a1]

Will one of the studs work on my Edelbrock performer carb for the transmission kick down linkage and for the two springs?

Home // Shop By Department > Truck & Jeep > Fuel > Carburetor Hardware > Carburetor Linkage Stud

I’ve found some factory looking ones on EBay.

The carb previously had a cobbled together machine screw

Also my throttle cable has some sort of plastic connector at the carburetor end. You can fit a machine screw through a hole to connect it up. I was wondering if there was something else that goes to it because that’s what it looks like.

The carb previously had is a 1974 Duster that came with a six banger.

 

[Professor Fate]

You need the Edelbrock Mopar linkage adapter in order to place the stud in the correct position.

Edelbrock 1481 Edelbrock Throttle Lever Adapters for Performer Carburetors | Summit Racing
Then your factory-type stud will work fine. Just make sure you get the right one for an automatic. Your link above doesn't show anything.

69-74 Mopar 318 340 360 383 440 4-Barrel Automatic Throttle Cable Linkage Stud | eBay