Snake
Mopar Nut
Hi,it's been a long time,my 71 plymouth 904 output shaft is leaking a bit, on Amazon I can get the Timkin # 7300s that's a name I like.can anyone confirm this seal fits.thanksss,kind of blew my mind they sell something like this.
71 904 output shaft seal
- Thread starter Snake
- Start date
-
Replace the bushing too.
Snake
Mopar Nut
Thanks very much.
Snake
Mopar Nut
Yes I thought of that thanks.
65TerrorCuda
Well-Known Member
Funny thing about the seal with boot-
Tom Hand's book says to install it with the vent hole up, then on the next page says to install it down. Calls it an air vent when it's up and weep hole when it's down. I'm putting my next one in sideways
Tom Hand's book says to install it with the vent hole up, then on the next page says to install it down. Calls it an air vent when it's up and weep hole when it's down. I'm putting my next one in sideways
Snake
Mopar Nut
Just did some research it looks like my transmission shop is the go to ,too remove the bushing and shaft seal.wish I had them do this when the tyranny was out having the shift kit installed some 6 years ago.
transman
Well-Known Member
Good move. They'll also have the parts in stock.
-
