[FOR SALE] 904 torque converter and flex plate

[connerray]

904 tc and flex plate from 318 magnum.
Flex plate has been "modified" to bolt to the torque converter
Torque converter was from a /6 trans but will work the same for v8 904.
40+ shipping for both. Ships from 72830. pics upon request.

 

[txstang84]

Did it give any stall over stock speed being that it was for a slant?

 

[connerray]

Never got to run it. Not even sure what a factory /6 setup stalls at.
But from my research, it should stall higher than what the 6 stalled at depending on how much more power your motor makes than a /6.

 

[txstang84]

Kinda as I would figure-there are members on here who suggest using a 340 stall behind a big block for a low buck higher stall converter option...

 

[connerray]

Mabey some one who has used this conveter behind a small block can chime in.. but other than that, its all a guessing game to me as to what it will do.
Obviously it will stall higher behind say a stroked 318 than a bone stock /6 but as I mentioned I don't even know the factory stall of the /6 904 combo.
I can do a little research in the am and try to come up with some numbers.

 

[connerray]

Done a quick search, came up with factory stall of 16-1800 and when placed behind a v8 it can flash 2200+ depending on how much power your making.

 

[txstang84]

Thanks for the research!

 

[connerray]

Sold my project dont need them, make me a reasonable offer

 

[connerray]

Make me an offer