I have a 1970 dart that had a 6 cyl. with 9" drum brakes in front. my question would be. I have a set of 10" baking plates and drums that were off a v8 car, can i swap them while useing the same upper control arms from the 9" set up?
front brake question
- Thread starter slx70
- Start date
-
805moparkid
Slant and AFX Guy
no you need the whole spindle...
the bearing sizes are different from the 9" spindle to the 10"
and early 10" spindles have the small ball joint so then it would be a no
but if you get the 73 and up brake parts yes you will need the upper control arm for BBJ
the bearing sizes are different from the 9" spindle to the 10"
and early 10" spindles have the small ball joint so then it would be a no
but if you get the 73 and up brake parts yes you will need the upper control arm for BBJ
-
