Need a Measurement

[scott657]

I need a horizontal measurement on a 360.
Distance between motor mount boss holes center to center.
I'm building an engine dolly/run stand
Thank you as always FABO

 

[scott657]

anyone?

 

[Bobzilla]

I just measured a 340 block I have easy access to.
Looks like 16.75 inches between the top holes, and 13.75 between the lower holes, both measured from the front of the engine, right side to left side, looking down on a tape measure. This measurement should be the same on 360. The front to rear distance is the difference between them.

 

[scott657]

thank you sooo much Bobzilla