non A/C alternator tube type spacers

[moparmat2000]

Hi Y'all,

I am building my 67 cuda with a 74 318. The 318 was an A/C equipped engine, and my cuda had a slanty.

I have a set of non A/C alternator brackets, and bolts, however i need the spacer tubes that go on the pivot bolt for the alternator.

I can make these if someone has all of them and is willing to post accurate length, and tube diameter dimensions.

Is there anybody on this forum who can do this??

Thanks in advance
Matt

 

[Princess Valiant]

one

 

[Princess Valiant]

Two : bigger of the two ....started at one inch mark

 

[Princess Valiant]

three: smaller of the two started at one inch mark ......

 

[moparmat2000]

Rainy day, you made my day
Diameter looks to be 5/8"
Lengths look to be 2&1/8"
And 1&1/8"

Gonna write this down in my little mopar book.

Thank you !!!
Matt

 

[Princess Valiant]

Rainy day, you made my day
Diameter looks to be 5/8"

Thank you !!!
Matt

yup 5/8"