fishy68
Tyr Fryr's Inc.
That's pretty low for a manual VB but not terrible like a stock converter. Lowering the line pressure may calm it down enough. Worth a shot.
BTW: it wasn't me that posted the pic. That was Trailbeast.
Reusing trans fluid
- Thread starter LocuMob
- Start date
-
That's pretty low for a manual VB but not terrible like a stock converter. Lowering the line pressure may calm it down enough. Worth a shot.
BTW: it wasn't me that posted the pic. That was Trailbeast.
LocuMob
Fluid Technician
Oops, Thanks go out to Trailbeast then.
I have to finish rebuilding the front end, so I'll climb under an extra time to adjust the line pressure. Can't wait to drive again.
TrailBeast
AKA Mopars4us on Youtube
You are welcome.
I realized when I went looking that I didn't have a pic like that and should for my collection anyhow.
LocuMob
Fluid Technician
I realized that I never did anything to the trans case when I swapped valve bodies. I just installed the steel cup and the blocker rod. Time for a test drive.
-
