Upper A-Arm bushings

[mad dog]

Im getting ready to rebuild some large bolt 73 upper control arms, I purchased proforged ball joints and now was wondering what is a good quality bushing to use.
Im useing the moog offset bushings in one set. Whats the go to bushings these days, thanks for the help..Rich

 

[junkyardhero]

moog offsets

K7103 (you need 2 sets, there's 2 bushings per)

 

[mad dog]

thanks jyh... i already have the k7103 to do a set of control arms. if i didnt want to use them on my other control arms what would you recommend for a bushing

 

[junkyardhero]

thanks jyh... i already have the k7103 to do a set of control arms. if i didnt want to use them on my other control arms what would you recommend for a bushing

these days, i won't use anything else. the ability to get some added caster is just a bonus.

if you're just slamming something together low rent because you're trying to send it then get whatever's cheap. they're all gonna be about the same.

 

[72bluNblu]

If you're going to run radial tires you should be running offset UCA bushings with stock UCA's.

 

[Tony Barracuda]

So I did a home rough alignment so I could drive it to the shop. My question is how far apart can the caster be from side to side? My goal is +2.5, so if one side is +2.5 does the other side have to be 2.5. Same with camber goal is -.5 does it have to match. Right now I have roughly 1/8 toe in, Ft of control arms all the way out and rear all the way in. DS camber -1 and PS +1. I was going to shim the PS lower ball joint to try and get the camber a little closer.