Recent content by neals65

its located on the steering colomn with a 3 speed auto on the column in a 65 dart new or used will do thank you

i got a65 dart .manuel steering switch is located on the steering collumn in side the car on the column i own a66 dart power steering i know that wont work hoping someone has the correct one if i find the broke one ill post a picture

[rick i need the shank style with washers if you have washersQUOTE="neals65, post: 1971533590, member: 45892"]just got em off your site hope i ordered the ones that spin on clockwise probablly the right ones thank you glad you had em

the ones i need take a 11sixteens wrench 7 sixteens thread i looked on summitt icould only find 3fourths and 13 16 so i may want to email rick obout the correct ones now that i see that there was a few that may not work

just got em off your site hope i ordered the ones that spin on clockwise probablly the right ones thank you glad you had em

looking for 10 early a body lug nuts and washers to fit the smaller bolt hole mopar craiger rims not unilugs i need the ones that turn to the right and loosen counter clockwise thank you

i got my 65 dart 273 2barrel carter carb i change it over to hei electronic ignition it has a 2.93 single trac 904 auto stock i removed ac unit it has p steering it runs good 25000 miles on rebuilt motor its stock manifolds with 2 inch duel exaust cherry bombs out the back . i got a 93 360...

neal@wind stream.net thankyou

i have a couple power steering 65 darts ive been steeling off to keep the driver going illbuy the stuff the the pulleys i cant find .ill buy a kit for 14 bucks and rebuild. like i say i need it if its the correct one. my buddy gave me one from a a 67 or later abody the front end of small...

i have a pay pal account ill use that if its ok thank you

how do i go about paying you for it

it is pressed on

ill try to post a picture this week i do know the pulley is 5 inches.thank you