Search results for query: *

Looking for either tinted 1/4 glass assemblies or near perfect tinted 1/4 glass for 70-72 Duster 71-72 Dodge Demon. Driver side especially. please pm Thanks James Lower Mainland B.C. Canada

Just finished installing my 360 and 727 transmission in my 71 Demon. The top two bolt sizes, left and right of centre are 3/8 coarse, the bottom 4 are 7/16 coarse...what sizes are the ones in between...the bolt hole where the transmission dipstick tube mounts and the opposite one on the other...

Greetings once again, Purchased the flaming river 16:1 manual box and have it bolted to the K-member of my 71 Demon. I have tried installing a new DLZ brand p/n K7074 pitman arm but it is too tight and will not go on far enough...aprx 3/8 inch short of being flush...super tight to wrench...

Good morning, Trying to sort out the parts list to complete my 71 Demon front end rebuild. Going to run the Hotchkis upper control arm pn# 1112. Large Ball joint part. They do make a 1112-s for the smaller ball joints 67-72. But pricing right now is much cheaper on the 1112 ones. My...

Greetings, Looking for a "good" small block v8 k member 71-72 Thanks James Located in B.C. Canada but can be shipped to Washington State

Good afternoon, I understand the lower control arms for the 66-72 and 73-76 are very similar with the exception of the sway bar mounts if they were factory installed. Centered on the 73-76 and end mounted on 66-72. My question is will the 73-76 lower control arms (installed on a 71...

Good morning from B.C. 71 Demon Califonia Car! I am reinstalling a new gas tank c/w the 5 outlets on the new fuel tank that go to the fueline return and the 4 that go to the trunk mounted charcoal canister. Does anyone have a schematic of the gas line routing for this car. It has...