JamesRR
Well-Known Member
I am currently piecing together a new rear end for my 66 Barracuda. I am putting in an 8 3/4 set up with a 741 case. Stock style small bolt axles with original style bearings. The questions I have are... :
1) Are there any washers or lock washers used for the nuts that connect the case to the axle housing? 2)What torque should the case be connected with? 3)Are there any washers for the nuts that connect the backing plates to the axles? 4)Torque for backing plates? Also what is the deal with the adjuster on the right axle? 5)How much play should there be? Thank you!
James
1) Are there any washers or lock washers used for the nuts that connect the case to the axle housing? 2)What torque should the case be connected with? 3)Are there any washers for the nuts that connect the backing plates to the axles? 4)Torque for backing plates? Also what is the deal with the adjuster on the right axle? 5)How much play should there be? Thank you!
James