JoJo
Well-Known Member
This is my first attempt of block honing. I purchased the Lisle Engine Hone that has the three stones. I went through all cylinders at 30 seconds each cylinder (1 full stroke = 1 second)...
End result:
Should I go back over the cylinders with the same process or that's fine as long as it's honed where the rings make contact?
End result:
![2zdxc1s.jpg](http://i42.tinypic.com/2zdxc1s.jpg)
Should I go back over the cylinders with the same process or that's fine as long as it's honed where the rings make contact?