marianamaya
Well-Known Member
OK Guys, I need some help!
I had an electrical problem where the fusible link on the ignition blew. It melted the large red wire on both sides of the underdash connector. I am trying to remove the harness from the steering column, and I am stuck.
It is a Slant 6 904 automatic.
I have the service manual and I am working off of page 19-35. I am working under the Steering Shaft section and I am stuck at #4 - "Pry sleeve off steering shaft lock plate hub to expose pin"
Can anyone help take me the rest of the way?
Any advice?
Thanks,
Pete
I had an electrical problem where the fusible link on the ignition blew. It melted the large red wire on both sides of the underdash connector. I am trying to remove the harness from the steering column, and I am stuck.
It is a Slant 6 904 automatic.
I have the service manual and I am working off of page 19-35. I am working under the Steering Shaft section and I am stuck at #4 - "Pry sleeve off steering shaft lock plate hub to expose pin"
Can anyone help take me the rest of the way?
Any advice?
Thanks,
Pete